|
|
Welcome to Saab92x.com! |
|
|
I have collected this information on my PDA over the last year whenever I needed to order things for our car. Figured I would share it to those who might need this info:
9-2x Subaru Part Numbers
Liquids
Genuine Subaru Long Life Coolant (P/N SOA868V9210 or SOA635002)
Subaru Coolant Conditioner - SOA635071
Subaru 75w-90 Extra-S Gear Oil GL-5 (Subaru Part #K0323F0091 )
___________________________________
Filters
Cabin Air Filter (P/N G3210FE100)
Engine Airbox Filter (P/N 16546AA020)
Engine Oil Filter (P/N 15208AA100)
Engine Oil Filter Crush Washer 11126AA000
___________________________________
Gaskets
Exhaust Gasket - Exhast Manifold 14038AA000
These are the butterfly-wing shaped gaskets that go between the headers and the engine
Exhaust Gasket - Center Of The Downpipe (44011FE000)
This is the gasket found between the two pieces of your downpipe.
Exhaust Gasket - Crossover Pipe (Drivers side: 44022AA160)
(Passenger side (with the tab that sticks out): 44011FA020)
This is the factory gasket for the union between the crossover pipe and the collector. The crossover and collector are often disconnected during uppipe installs, and the gasket should be changed if this happens.
Exhaust Gasket - Graphite Donut (44022AA122)
This is the graphite donut found between your downpipe and the midpipe (the joint with the spring bolts) on the WRX and WRX-STi.
Exhaust Gasket - Midpipe To Muffler (44022AA131)
This is the gasket you will find between the midpipe and the muffler on the WRX and WRX-STi.
Exhaust Gasket - Turbo To Downpipe (44022AA180)
This is the factory gasket found between your turbocharger and downpipe. Get a new one when you do that downpipe install to ensure a proper seal.
Exhaust Gasket - Uppipe To Turbo (44022AA150)
This is the factory gasket for the union between the uppipe and the turbocharger. You need to replace this gasket should you remove your uppipe or your turbo.
Exhaust Gasket - Headers To Uppipe (44022AA170)
This is the gasket found between the headers and the uppipe. It should be changed whenever you remove the uppipe or headers or install new ones, to ensure a good seal.
Intercooler BPV Gasket - 21896AA072
Transmission Drain Plug Gasket - #803926070
___________________________________
Bolts and Nuts
Upper Endlink bolt that connects to swaybar (comes with washer and locking washer): PART# 901250054
Lower Endlink Bolt: PART# 016710553
Endlink Nuts (same for upper/lower): PART# 902370029
Dowpipe/Uppipe:
Nut: 902370029
Flange Bolt: 44059AA030
Stud: 800910340
Trans Drain Plug 5MT - #32103AA080
__________________
Various Things:
2005 STi Air Splitter 90817FE200
2005 STi Air Splitter Bellows/Duct 90817FE210
Wagon Rear Wiper Refill SOA591U314R
Saab 9-2X OEM Mats: Saab Part#0293902
Subaru WRX OEM Carpet Mats: #J5010SS001OE
Subaru Impreza Rubber Mats: #J5010SS300
Subaru 20mm Rear Stabilizer Bar: 20451FE000
Subaru 17mm Rear Stabilizer Bar Bushing: 20464FE060
Last edited by Whateverland (2007-10-25 21:21:18)
Offline
Offline
Very .
Offline
Mats???? What part #???
Offline
eurospek wrote:
Mats???? What part #???
DUDE WTF! Don't crap on an informative thread.
Regardless... talking mats:
Saab 9-2X OEM Mats: Saab Part#0293902
Subaru WRX OEM Carpet Mats: #J5010SS001OE
Subaru Impreza Rubber Mats: #J5010SS300
Offline
If anyone has any part number info to share, feel free to respond and i will edit the original post. I can also try to make this more comprehensive by also putting the matching saab part #'s
Offline
Subaru 20mm Rear Stabilizer Bar: 20451FE000
Subaru 17mm Rear Stabilizer Bar Bushing: 20464FE060
Offline
very useful, john_matrix stickied this
also it's important to note that Whateverland has all of these parts in stock and you can order from him... each time he needs a part he just buys four or five of them to make sure he has enough
Offline
Nice post!!
Offline
iota wrote:
very useful, john_matrix stickied this
also it's important to note that Whateverland has all of these parts in stock and you can order from him... each time he needs a part he just buys four or five of them to make sure he has enough
The funny part is.... is that you aren't really lying
Offline
Good thread especially for the exhaust gaskets and such.
Offline
red92xblue wrote:
hello all anyone have the oem( subaru ) brake pad numbers for the front and rear. thanks
Edit: These are based off the 2002 WRX, I'm pretty sure it's the same for the 2005 WRX but I would check first with whoever you order from.
Front brake Pad Kit: 26296 (26296FE060)
Rear brake Pad Kit: 26696A (26696FC002)
Last edited by Whateverland (2006-11-27 00:14:13)
Offline
Exhaust Gasket - Center Of The Downpipe (44011FE000)
This is the gasket found between the two pieces of your downpipe.
Is this what I need for a Short DP like a Bosal? Thanks guys!!!
Offline
Yes. Along with the "turbo to downpipe" gasket.
Offline
44022AA131 <-- correct part number
Exhaust Gasket - Midpipe To Muffler (44022A131)
This is the gasket you will find between the midpipe and the muffler on the WRX and WRX-STi.
Offline
and the 2002 front brake pads are different.
Offline
is the engine oil filter the same for the aero and linear??
Offline
added some stuff to original post
Offline
GREAT INFO!
Offline
Belt tensioner - I broke mine
Offline
Any cross references on touch up paint? Can we use the Subie paint codes?
Offline
BoxerWhoosh wrote:
Any cross references on touch up paint? Can we use the Subie paint codes?
Offline
Just bought a Forester Rear Wiper blade assembly to replace the OEM assembly.
The Forester OEM blade assembly is a 16" blade as opposed to the Saabaru OEM 14" assembly. Works like a charm. It has been mentioned in another thread.
Here is the Subaru part number 86542SA050. It was $17.19 at Go Subaru.
Offline
need remote key fob for 2005 92x linear....need subaru part number
Offline
Accessory not really a part but
Trunk Tray.
Saab # 32009590
Subaru # 95055FE000
ETA
Doesn't matter which box you open they both have the same thing inside
Last edited by Wagn762 (2008-09-05 13:50:36)
Offline
http://forums.nasioc.com/forums/showthr … ?t=1623020
New Oil Filter 15208AA12A
FROM: Subaru of America, Inc.
DEPARTMENT: Parts
DATE: 10/22/2008
SIA with the approval of FHI has changed their Oil Filter supplier for the 4 cylinder applications. As a result of this, we will be able to take advantage of this change on replacement service parts cost. The old number 15208AA100 (black in color) will be superseded to the new number 15208AA12A (blue in color) and will have a minimum order quantity of 12 (one case). The supersession is mutual so either filter can be used.
The new filter will be available on 10/22/08
Offline
|